OHATS

Ocean Horizontal Array Turbulence Study

PROJECT DATES

08/05/2004 - 09/05/2004

Project Location

Martha's Vineyard, Maryland

PROJECT DESCRIPTION

Introduction

This document describes the operation and measurements of the Integrated Surface Flux System (ISFS) during the Ocean Horizontal Array Turbulence Study (OHATS) field project in 2004.

Principle Investigators for the project are Peter P. Sullivan (MMM/NCAR), James B. Edson (WHOI), John C. Wyngaard (Penn State University), Thomas W. Horst (ATD/NCAR), Donald H. Lenschow (MMM/NCAR), Chin-Hoh Moeng (MMM/NCAR), and Jeffery C. Weil (CIRES, University of Colorado). Participation by James B. Edson and John C. Wyngaard has been funded by a grant from the National Science Foundation.

Sonic Array Design

The OHATS sonic array design was changed from that used during the HATS field project, based on the experience gained during the data analysis phase of HATS. These changes were the use of nine sonics in both of the two, vertically-displaced lines of sonics and a smaller vertical spacing between the two lines. Click on the link for discussion of the reasons for these changes and the results of a pre-project flow distortion test of the new array design.

Schedule

April 1st - July 23rd
- Pre-project testing at NCAR
July 25th - August 3rd
- Deployment of sonic anemometer array on WHOI ASIT south of Martha's Vineyard
August 3rd - October 26th
- Operations
October 26th
- Sensors and data system removed from ASIT

Measurement Site

Two horizontal arrays of nine CSAT3 sonic anemometers were deployed at heights of 5 and 5.58 m above msl on the Woods Hole Oceanographic Institute (WHOI) Air-Sea Interaction Tower (ASIT), 3 km south of Martha's Vineyard in 15 m of water.

Other measurements, provided by WHOI and ingested by the ISFF data system, include an independent CSAT3 sonic at a height of 9 meters, collocated with a Licor 7500 fast water vapor and CO₂ sensor and a Vaisala hygrothermometer; three laser wave height sensors; and an inertial motion package, MotionPak, attached to the crosswind array.

Field Logbook

A computer-readable field logbook of comments by NCAR and other personnel is available in read-only html form. A separate logbook exists for the pre-project flow distortion tests at Marshall, CO.

Data Plots

The 5 minute statistics for most variables are shown on time-series plots for each day. The periods of the plots extend for 36 hours, from 1800 EST the preceding day until 0600 EST the following day.

Good Data Periods

good.dir_.xls is an MS Excel spreadsheet showing a preliminary assessment of the periods of good data, based on a wind direction within ± 45° of normal to the array. The spreadsheet lists the date, start time, and length of each good data period, wind speed and direction, z/L, and the standard deviation of the wave height measured by the laser altimeters.

Sonic Calibration and Data Corrections

The CSAT3 sonics were calibrated by the manufacturer prior to the field program. However, wind tunnel testing after the project showed offsets on the order of 10 cm/s for four of the 19 sonics.

The sonic data must be rotated to correct them for sensor tilt. Unfortunately the planar fit method, which is based on removing the mean, non-zero vertical velocity, is not applicable to this data due to flow distortion upwind of the ASIT tower. See Sonic Calibration and Data Corrections for a discussion of the wind tunnel tests and how the data have been corrected.

Data Download

The data are available in NetCDF form in two datasets: